Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPLYMOUTH1984HORIZON BASE, 1.6 AREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 61 (AXLE SHAFTS - FRONT)TORQUE SPECIFICATIONS
1984 Plymouth Horizon Base, 1.6 A
Torque Specifications
1984 Plymouth Horizon Base, 1.6 ASECTION Torque Specifications
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 1989 Plymouth Sundance, 1989 Plymouth Reliant, 1989 Plymouth Horizon, 1989 Plymouth Acclaim, and 1989 Dodge Spirit. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Ball Joint Clamp Bolt | 70 (95) | |
| Brake Caliper Bolt | 160 (217) | |
| Brake Hose Retainer Bolt | 10 (14) | |
| Damper Weight Bolt | ||
| S.S.G. | 21 (28) | |
| G.K.N. | 23 (31) | |
| Hub Bearing Retainer Bolt | 20 (27) | |
| Inner CV Joint Flange | 36 (49) | |
| Intermediate Shaft | ||
| Bracket-to-Bearing Bolt | 21 (28) | |
| Bracket-to-Engine Bolt | 40 (54) | |
| Spindle Nut | 180 (244) | |
| Tie Rod Nut | 35 (47) | |
| Wheel Nut | 95 (129) | |
| INCH Lbs. (N.m) | ||
| Damper Weight Bolt (A.C.I.) | 96 (11) | |
| Speedometer Gear Bolt | 60 (7) | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.