Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPLYMOUTH1984HORIZON BASE, 1.6 AREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 40 (ENGINE COOLING FAN)COOLING SYSTEM SERVICINGMAINTENANCEFLUSHING
1984 Plymouth Horizon Base, 1.6 A
Cooling System Servicing: Maintenance: Flushing
1984 Plymouth Horizon Base, 1.6 ASECTION Flushing
WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 1985 Plymouth Turismo, 1985 Plymouth Reliant, 1985 Plymouth Horizon, 1985 Plymouth Gran Fury, and 1985 Plymouth Caravelle. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Some manufacturers use an aluminum/plastic radiator on some models (identified by a note below the filler neck). Material used for cleaning and flushing must be compatible with aluminum, according to manufacturer's recommendations.
- Back flushing is a very effective means of removing rust and scale from a cooling system. For best results, the radiator, engine and heater core should be flushed separately.
- To flush radiator, connect flushing gun to water outlet of radiator and disconnect water inlet hose. Use a leadaway hose, connected to radiator inlet, to prevent flooding the engine. Use air in short bursts only as a clogged radiator could be easily damaged. Continue flushing until water runs clear.
- To flush engine, first remove thermostat and replace housing. Connect flushing gun to water outlet of engine. Disconnect heater hoses from engine. Flush using short air bursts until water runs clean. Flush heater core as described for radiator. Make sure heater valve is set to maximum heat position before flushing heater.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.