Entering DRB Main Menu

1984 Plymouth Horizon Base, 1.6 ASECTION Entering DRB Main Menu
WARNING: This page is about a different car, the 1994 Plymouth Sundance, 1994 Plymouth Acclaim, 1994 Dodge Spirit, 1994 Dodge Shadow, and 1994 Chrysler LeBaron. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure ignition is off. Attach DRB to Chrysler Collision Detection (CCD) data link connector. Data link connector is located behind fuse access cover on lower section of dash panel, left of steering column. See Figure. Turn ignition switch to RUN position.
  2. All DRB character positions will glow and copyright information will appear on screen for a few seconds. DRB main menu will appear after a few seconds. If DRB screen is blank, NO RESPONSE message is displayed, or any error messages appear, see DRB PROBLEMS & ERROR MESSAGES.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.