Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPLYMOUTH1984HORIZON BASE, 1.6 AREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTSTEERING COLUMN SWITCHESREMOVAL & INSTALLATIONSPEED CONTROL SWITCHREMOVAL
1984 Plymouth Horizon Base, 1.6 A
Speed Control Switch: Removal
1984 Plymouth Horizon Base, 1.6 ASECTION Removal
- Disconnect main fusible link in engine compartment. Remove steering column trim cover. On vehicles with tilt steering column, remove wiring trough from column.
- Position gearshift lever to its full clockwise position (midpoint for tilt steering columns). Disconnect speed control switch wiring harness connector. Remove turn signal attaching screw, lever, and harness from column.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.