Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSPLYMOUTH1974FURY III 4D HARDTOP, 5.9L ENG VIN JREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONSPECIFICATIONS INDEXAIR CONDITIONING SERVICINGREFRIGERANT CAPACITY
1974 Plymouth Fury III 4D Hardtop, 5.9L Eng VIN J
Refrigerant Capacity
1974 Plymouth Fury III 4D Hardtop, 5.9L Eng VIN JSECTION Refrigerant Capacity
O.E.M. REFRIGERANT TABLE
| Application | Capacity (Lbs.) | ||
|---|---|---|---|
| American Motors | |||
| Gremlin, Hornet, Javelin | 2 | ||
| Ambassador, Matador | 3 1/4 | ||
| Chrysler Corp. | |||
| Dart, Valiant | 3 1/4 | ||
| Charger, Coronet, Satellite, Challenger, Barracuda | 2 3/4 | ||
| Chrysler, Fury, Imperial, Monaco | 5 | ||
| Ford Motor Co. | |||
| Comet, Maverick | 1 7/8 | ||
| Continental, Cougar, Ford, Mark IV, Mercury, Meteor, Montego, Thunderbird, Torino | 4 1/4 | ||
| Mustang | 3 1/4 | ||
| Pinto | 2 1/4 | ||
| General Motors | |||
| Buick | |||
| All Exc. Apollo | 4 | ||
| Apollo | 3 3/4 | ||
| Cadillac | |||
| All Exc. Fleetwood 75 | 4 | ||
| Fleetwood 75 | 5 1/4 | ||
| Chevrolet | |||
| All Exc. Corvette, Vega | 3 3/4 | ||
| Corvette | 3 | ||
| Vega | 2 13/16 | ||
| Oldsmobile | |||
| All Models | 4 | ||
| Pontiac | |||
| All Exc. Firebird, Ventura II | 4 | ||
| Firebird | 3 1/4 | ||
| Ventura II | 3 1/4 | ||
| Jeep | 2 1/4 | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.