Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE1998AURORA V8-4.0L VIN CREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLESERVICE AND REPAIROVERHAULSUBASSEMBLY SERVICEFOURTH SERVO REMOVAL
1998 Oldsmobile Aurora V8-4.0L VIN C
Fourth Servo Removal
1998 Oldsmobile Aurora V8-4.0L VIN CSECTION Fourth Servo Removal
1. Remove the three 10-mm bolts (534) from the servo cover.
IMPORTANT: Hold the servo cover in place until all of the bolts are removed. If this is not done, the apply pin will damage the bore.
2. Remove the following parts:
^ The servo cover (524)
^ The servo assembly (529)
^ The spring (533)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.