Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE1998AURORA V8-4.0L VIN CREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSMANIFOLD PRESSURE/VACUUM SENSORSERVICE AND REPAIR
1998 Oldsmobile Aurora V8-4.0L VIN C
Manifold Pressure/Vacuum Sensor: Service and Repair
1998 Oldsmobile Aurora V8-4.0L VIN CSECTION Service and Repair
Description:
REMOVAL PROCEDURE
1. Remove the intake manifold top cover.
2. Disconnect the crankcase breather tube from the throttle body.
3. Remove the MAP sensor from the intake manifold.
4. Disconnect the MAP sensor electrical connector.
5. Inspect the MAP sensor grommet for wear or damage and replace as needed.
INSTALLATION PROCEDURE
1. Connect the MAP sensor electrical connector.
2. Install the MAP sensor into the intake manifold.
3. Connect the crankcase breather tube to the throttle body.
4. Install the intake manifold top cover.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.