Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit Description
Powertrain Control Module (PCM) has 4 injector driver circuits, one for each injector. PCM monitors current in each driver circuit by measuring a voltage drop through a fixed resistor and is able to control it. Current through each driver is allowed to rise to a peak or 4-amps to quickly open injectors. Current is then reduced to one amp to keep injector open. If current cannot reach 4-amps or injector driver is shorted to voltage, DTC P0200 will set.
Conditions for setting this DTC are as follows:
- Injector current less than 4 amps.
- Battery voltage greater than 9 volts.
- Conditions met for 5 seconds.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.