Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE1998ACHIEVA 3.1 M, 4T40E/MN4REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 6 (BODY CONTROL MODULES)DIAGNOSTIC TESTSDTC U1300: CLASS 2 CIRCUIT (SHORT TO GROUND)TESTING
1998 Oldsmobile Achieva 3.1 M, 4T40E/MN4
DTC U1300: Class 2 Circuit (Short To Ground): Testing
1998 Oldsmobile Achieva 3.1 M, 4T40E/MN4SECTION Testing
WARNING: This page is about a different car, the 1999 Buick Regal and 1999 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
- Perform Data Link Connector (DLC) diagnostic system check. Go to DLC DIAGNOSTIC SYSTEM CHECK under SYSTEM TESTS. After DLC diagnostic system check is performed, go to next step.
- Turn ignition on. Using scan tool, clear DTCs. Check for DTCs. If DTC U1300 is set, go to next step. If DTC U1300 is not set, go to step 4 .
- Class 2 serial data link circuit is okay. Module that is setting DTC has internal malfunction. Go to appropriate diagnostic and repair procedures. After repairs, go to step 5 .
- System is operating properly at this time. See DIAGNOSTIC AIDS . After any repairs are made, go to next step.
- Turn ignition off. Reinstall all components and connectors. Turn ignition on. Using scan tool, clear DTCs. Check for DTCs. If any DTCs are current, perform BCM DIAGNOSTIC SYSTEM CHECK under SYSTEM TESTS. If no DTCs are current, system is operating properly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.