Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE1998ACHIEVA 3.1 M, 4T40E/MN4REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 6 (BODY CONTROL MODULES)DIAGNOSTIC TESTSDTC B1007: BCM INTERNAL MEMORY MALFUNCTION (WRITE ERROR)TESTING
1998 Oldsmobile Achieva 3.1 M, 4T40E/MN4
DTC B1007: BCM Internal Memory Malfunction (Write Error): Testing
1998 Oldsmobile Achieva 3.1 M, 4T40E/MN4SECTION Testing
WARNING: This page is about a different car, the 1999 Buick Regal and 1999 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
- If BCM diagnostic system check was performed, go to next step. If BCM diagnostic system check was not performed, go to BCM DIAGNOSTIC SYSTEM CHECK under SYSTEM TESTS.
- Using scan tool, clear BCM DTCs. See BCM DTC DEFINITIONS under SELF-DIAGNOSTIC SYSTEM. Turn ignition off. Wait 10 seconds. Turn ignition on. Using scan tool, check for codes. If DTC B1007 is set, go to next step. If DTC B1007 is not set, go to step 4 .
- Replace BCM. See BODY CONTROL MODULE (BCM) under REMOVAL & INSTALLATION. Reprogram BCM. See NEW BCM SETUP under PROGRAMMING. Go to step 5 .
- System is operating properly at this time. See DIAGNOSTIC AIDS .
- Turn ignition off. Reinstall all components and connectors. Turn ignition on. Using scan tool, clear DTCs. Check for DTCs. If any DTCs are current, perform BCM DIAGNOSTIC SYSTEM CHECK under SYSTEM TESTS. If no DTCs are current, system is operating properly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.