Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit Description
Circuit No. 1459 (White wire) supplies voltage from BCM to Passlock(R) sensor. DTC B2947 will set when Passlock(R) power is active and Passlock(R) power feedback is not present for 1 second. When DTC is set, BCM will turn off Passlock(R) power as long as fault is set. When starting vehicle, it will immediately stall and SECURITY indicator will remain on. BCM will go to sleep and wake up after fault is cleared. DTC will clear from history after ignition switch is cycled on and off 100 times with no faults present. DTC can also be cleared using scan tool.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.