Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE1998ACHIEVA 3.1 M, 4T40E/MN4REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 26 (ENGINE CONTROL SYSTEM - TESTS W/CODES - INTRODUCTION)SELF-DIAGNOSTIC SYSTEMON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK3.8L
1998 Oldsmobile Achieva 3.1 M, 4T40E/MN4
On-Board Diagnostic (OBD) System Check: 3.8L
1998 Oldsmobile Achieva 3.1 M, 4T40E/MN4SECTION 3.8L
WARNING: This page does not describe the selected car, but rather 68 other vehicles, including the 1999 Saturn SW2, 1999 Saturn SW1, 1999 Saturn SL2, 1999 Saturn SL1, and 1999 Saturn SL. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Check for applicable Technical Service Bulletins (TSBs) before proceeding. DO NOT perform the following procedure if driveability conditions are not present. DO NOT turn ignition off during the following procedure or clear DTCs unless instructed to do so.
- Turn ignition on, with engine off. Observe MIL. If MIL illuminates, go to next step. If MIL does not illuminate, go to MIL INOPERATIVE .
- Turn ignition off. Connect scan tool. Turn ignition on. If scan tool displays PCM data, go to next step. If scan tool does not display PCM data, go to DLC DIAGNOSIS OR NO SCAN TOOL DATA .
- Attempt to start engine. If engine starts and continues to run, go to next step. If engine does not start, or starts and stalls, go to NO START DIAGNOSIS in appropriate BASIC DIAGNOSTIC PROCEDURES article.
- Using scan tool, observe DTC status for MIL REQUEST, FAIL THIS IGN, LAST TEST FAIL and HISTORY. If any DTCs are stored, save freeze frame and failure records information using scan tool CAPTURE INFO feature. Diagnose DTCs. See DIAGNOSTIC TESTS in appropriate TESTS W/CODES article. If DTCs are not present, go to next step.
- Compare PCM data values displayed on scan tool with typical control system data values. If values are within limits, system is okay. If values are not within limits, see appropriate SYSTEM & COMPONENT TESTING article.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.