Vehicle Driveability Computer Relearn Procedure (M/T Models)

1998 Oldsmobile Achieva 3.1 M, 4T40E/MN4SECTION Vehicle Driveability Computer Relearn Procedure (M/T Models)
WARNING: This page does not describe the selected car, but rather 69 other vehicles, including the 1999 Saturn SW2, 1999 Saturn SW1, 1999 Saturn SL2, 1999 Saturn SL1, and 1999 Saturn SL. However, it is still accessible from the selected car via links, so may be relevant.
  1. If vehicle battery was disconnected or Powertrain Control Module (PCM) was replaced, turn ignition off. Reconnect PCM battery feed. Turn A/C off. Set parking brake and block drive wheels. Shift transmission into Neutral.
  2. Start engine. Idle engine until it reaches operating temperature. Allow engine to idle for 5 minutes. Turn engine off for 30 seconds. Vehicle should now be returned to learned idle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.