Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE1998ACHIEVA 3.1 M, 4T40E/MN4REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 18 (SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM)REMOVAL & INSTALLATIONFRONT-END DISCRIMINATING SENSORREMOVAL
1998 Oldsmobile Achieva 3.1 M, 4T40E/MN4
Front-End Discriminating Sensor: Removal
1998 Oldsmobile Achieva 3.1 M, 4T40E/MN4SECTION Removal
WARNING: This page is about a different car, the 1998 Pontiac Sunfire and 1998 Chevrolet Cavalier. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding, see SERVICE PRECAUTIONS . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM .
- Forward discriminating sensor is located next to hood latch bracket. Remove CPA clip and disconnect sensor connector. Remove sensor mounting fasteners. Remove sensor. See Fig 1 .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.