Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE1998ACHIEVA 3.1 M, 4T40E/MN4REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 15 (ENGINE CONTROLS - TESTS W/CODES - 3.1L)DIAGNOSTIC TROUBLE CODESDTC P0325 - KNOCK SENSOR MODULE CIRCUITDIAGNOSTIC PROCEDURES
1998 Oldsmobile Achieva 3.1 M, 4T40E/MN4
Diagnostic Procedures
1998 Oldsmobile Achieva 3.1 M, 4T40E/MN4SECTION Diagnostic Procedures
WARNING: This page is about a different car, the 1998 Oldsmobile Cutlass and 1998 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
- Perform POWERTRAIN ON-BOARD DIAGNOSTIC (OBD) SYSTEM CHECK , then go to next step.
- If engine knock can be heard, repair engine mechanical problem before proceeding with test. Operate vehicle within conditions required to set DTC. Using scan tool, select DTC, SPECIFIC function and enter this DTC. If scan tool display shows DTC P0325 FAILED THIS IGN, go to step 4). If scan tool display does not show DTC P0325 FAILED THIS IGN, go to next step.
- Turn ignition on, engine off. Read and record FAIL RECORDS data for DTC P0325. Operate vehicle within conditions noted in FAIL RECORDS data. Using scan tool, read SPECIFIC DTC. If scan tool displays DTC P0325 FAILED THIS IGN, go to next step. If scan tool does not display DTC P0325 FAILED THIS IGN, see DIAGNOSTIC AIDS.
- Replace PCM. Program replacement PCM using required equipment. After replacing PCM, go to next step.
- Using scan tool, read and record FAIL RECORDS DATA, and clear DTCs. Operate vehicle within conditions noted in FAIL RECORDS data. Using scan tool, select SPECIFIC DTC INFO for DTC P0325. Monitor scan tool until DTC P0325 test runs. If scan tool displays DTC P0325 FAILED THIS IGN, repeat step 2). If scan tool does not display DTC P0325 FAILED THIS IGN, system is okay.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.