Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Aids
Check for damages or sticking throttle plate or IAC valve. A throttle valve place or IAC valve that allows too much airflow while throttle should be closed may cause a high idle and DTC P0121 to set.
A skewed MAP signal or faulty MAP sensor or an incorrect MAP signal may cause PCM to incorrectly calculate the predicted TP sensor value during high engine load situations. Check for an unusually low MAP reading. This condition can cause DTC to set.
Check for poor connections at PCM. Inspect harness connectors for backed out terminals, improper mating, broken locks, improperly formed or damaged terminals, and poor terminal-to-wire connection.
If DTC cannot be duplicated, the information included in the FAIL RECORDS data can be useful in determining vehicle mileage since DTC was last set. If it is determined that DTC is intermittent, performing DTC P1121 or P1122 diagnosis may isolate cause of fault.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.