SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE1995CUTLASS CIERA L4-2.2L VIN 4REPAIR AND DIAGNOSISSTEERING AND SUSPENSIONSTEERINGSTEERING COLUMNSERVICE AND REPAIRWITH STANDARD COLUMNIGNITION SWITCH
1995 Oldsmobile Cutlass Ciera L4-2.2L VIN 4

Ignition Switch

1995 Oldsmobile Cutlass Ciera L4-2.2L VIN 4SECTION Ignition Switch

Fig. 2 Ignition & Dimmer Switch Replacement. Fixed Column:






WARNING:
On models equipped with Airbags, Refer to Air Bags (Supplemental Restraint Systems) Service and Repair Disarming procedures before performing any repair. Service and Repair

1. Remove ignition lock. Refer to Ignition Lock / Service and Repair.
2. Refer to Fig. 2 for ignition and dimmer switch replacement procedures.
3. Remove washer and hex nut.
4. Disconnect dimmer switch assembly from rod.
5. Remove dimmer switch and ignition switch mounting stud.
6. Remove ignition switch from ignition switch actuator assembly.
7. Disconnect turn signal switch assembly electrical connector from bulkhead connector.
8. Remove pivot and switch assembly connector from bulkhead connector.
9. Reverse procedure to install.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.