Engine Controls - Diagnostics For Internally Shorted IAC

1989 Oldsmobile Delta 88 V6-3800 3.8LSECTION Engine Controls - Diagnostics For Internally Shorted IAC
89oldsmobile

SUBJECT DIAGNOSTIC PROCEDURES FOR INTERNALLY
SHORTED IDLE AIR CONTROL MOTORS


MODELS/YEARS 1988-89 CUTLASS CIERA, NINETY-EIGHT, EIGHTY-
EIGHT, TORONADO AND CUTLASS CALAIS WITH
3300, 3800 ENGINES
NUMBER: 89-T-72

CORP. REF. NO: 916505R

DATE: May 1989

SECTION: 6E
We have recently seen a few cases of internally shorted Idle Air Control Motor terminals on 1988 and 1989 models equipped with 3800 engines, and 1989 models equipped with 3300 engines, which may exhibit one or more of a variety of poor driveability conditions. Some of those conditions could include:

1. Engine miss at idle or rough idle (engine can be hot or cold).
2. Engine miss under light acceleration.
3. General engine roughness at all engine speeds.
4. Cycling whine (generator) accompanied by fluctuating RPM at Idle (3 or 4 times at each stop).
5. Chuggle at approximately 45 mph.
6. Excessive rattle from EGR valve (some noise is normal).
7. Transmission comments about 3-4 shifts (rough or repetitive 4th gear engagements).
8. Comments about T.C.C. operation (rough, shudder).

It should be noted that each vehicle may exhibit different symptoms and these sometimes can be intermittent. Although this condition is not very wide spread, it can be very difficult to diagnose unless the following procedure is used, since an IAC motor is not generally associated with these types of comments.

A quick test of the IAC motor can be performed by simply disconnecting the harness connector at the IAC motor and determining if the poor driveability condition is eliminated or not. The harness should be disconnected with the engine running and the IAC motor counts stabilized.

If the symptoms are still present with the IAC motor disconnected, DO NOT REPLACE THE IAC MOTOR. At this point, it will be necessary to reconnect the IAC motor and refer to the appropriate Service Manual for further diagnostics.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.