SYS.OK|MANUAL.DB● LIVE
1987 Oldsmobile Firenza Base, 4D Sedan, 2.0 K, Automatic

Quick Lookups: Fluids

1987 Oldsmobile Firenza Base, 4D Sedan, 2.0 K, AutomaticSECTION Fluids
FLUID CAPACITIES
Fluid Type Application Standard Metric Fluid Spec Note S/H
Automatic Transmission Fluid Trans Mfr CD 125C/MD9 Overhaul 6.00 QTS. 5.67 L Automatic Transmission Fluid DEXRON VI Refer to TSB No. 04-07-30-037C, Date of Issue: April 11, 2007. S
Automatic Transmission Fluid Trans Mfr CD 125C/MD9 Pan Removal and Replacement 4.00 QTS. 3.78 L Automatic Transmission Fluid DEXRON VI Refer to TSB No. 04-07-30-037C, Date of Issue: April 11, 2007. S
Brake Fluid N/A N/A DOT 3 Brake Fluid S
Engine Coolant 2.0L Eng,Eng VIN 1 11.25 QTS. 10.64 L 50/50 mixture of Ethylene Glycol Base Antifreeze and water GM Specification 1825-M. S
Engine Coolant 2.0L Eng,Eng VIN 1 w/Air Cond 12.00 QTS. 11.35 L 50/50 mixture of Ethylene Glycol Base Antifreeze and water GM Specification 1825-M. S
Engine Coolant 2.0L Eng,Eng VIN K 8.00 QTS. 7.57 L 50/50 mixture of Ethylene Glycol Base Antifreeze and water GM Specification 1825-M. S
Engine Oil 2.0L Eng 4.00 QTS. 3.78 L SAE 5W-30 (Preferred) (Below -20Deg.F to over 100Deg.F), 10W-30 (0Deg. to over 100Deg.F), 30 (40Deg.F to over 100Deg.F) S
Fuel Tank 13.50 GALS. 51.1 L S
Power Steering Fluid Complete System 2.25 PTS. 1.06 L GM Power Steering Fluid GM Part No. 1050017. S
Power Steering Fluid w/Pump 1.00 PTS. 0.47 L GM Power Steering Fluid GM Part No. 1050017. S
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.