Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE1987CUTLASS CIERA V6-231 3.8LREPAIR AND DIAGNOSISSTEERING AND SUSPENSIONSTEERINGSTEERING COLUMNSERVICE AND REPAIRIGNITION LOCK CYLINDER
1987 Oldsmobile Cutlass Ciera V6-231 3.8L
Ignition Lock Cylinder
1987 Oldsmobile Cutlass Ciera V6-231 3.8LSECTION Ignition Lock Cylinder
1. Remove steering wheel as outlined under ``Steering Wheel, Replace'' procedure.
2. Remove turn signal switch as outlined under ``Turn Signal Switch, Replace'' procedure.
3. Remove buzzer switch and spring clip.
4. Turn lock cylinder to ``Run'' position, then remove lock cylinder retaining screw and the lock cylinder.
5. To install, rotate lock cylinder to the stop while holding housing. Align cylinder key with keyway in housing, then push lock cylinder into housing until fully seated.
6. Install lock cylinder retaining screw, then the buzzer switch, turn signal switch and steering wheel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.