Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Electronic Control System
The electronic control system monitors engine operating conditions. The electronic control system then processes these conditions, and controls the engine for optimum performance and minimum emissions.
Input signals are generated by the Engine Coolant Temperature (ECT) sensor, Mass Airflow (MAF) sensor, Oxygen (O2) sensor, Throttle Position Sensor (TPS), Park/Neutral switch, Vehicle Speed Sensor (VSS), Manifold Air Temperature (MAT) sensor and Manifold Absolute Pressure (MAP) sensor.
Some 2.8L engines may use a combination of the MAF, MAT and MAP sensors. On 2.0L Turbo engines the MAP and MAT sensors are used to determine airflow. The ECM also receives signals from the starter solenoid, air conditioning selector switch and distributor.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.