Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE1987CALAIS BASE, 2D COUPE, 2.5 U, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEM2.3L VIN [D] CEC TESTS W/CODESDIAGNOSTIC CODE FLOW CHARTS (CODE CHARTS)CODE 43 - ELECTRONIC SPARK CONTROLNOTES
1987 Oldsmobile Calais Base, 2D Coupe, 2.5 U, Automatic
Code 43 - Electronic Spark Control: Notes
1987 Oldsmobile Calais Base, 2D Coupe, 2.5 U, AutomaticSECTION Notes
Code 43 indicates the ECM has seen high or low voltage at circuit No. 496 for longer than 5 seconds with the engine running.
NOTE:
Test numbers refer to test numbers on diagnostic chart.
- If conditions for test as described above are being met, Code 43 will currently set and the "SES" light will be illuminated.
- The ECM has a 5-volt pull-up resistor, which should be present at the knock sensor terminal.
- This test determines if internal resistance of knock sensor is within an acceptable range.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.