SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE1982CUTLASS CALAIS, 5.7L ENG VIN N, TRANS MFR CD 350C/MX2REPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSCOMPUTER COMMAND CONTROLOPERATIONDATA SENSORSOXYGEN SENSOR
1982 Oldsmobile Cutlass Calais, 5.7L Eng VIN N, Trans Mfr CD 350C/MX2

Oxygen Sensor

1982 Oldsmobile Cutlass Calais, 5.7L Eng VIN N, Trans Mfr CD 350C/MX2SECTION Oxygen Sensor

This sensor is mounted in engine exhaust stream. It supplies a low voltage (under 1/2 volt) when fuel mixture is lean (too much oxygen) and a higher voltage (up to 1 volt) when fuel mixture is rich (not enough oxygen). Oxygen sensor must be hot (over 600°F) to function properly. The oxygen sensor measures quantity of oxygen only. On some models, oxygen sensor may cool off during idle, causing CCC system to go into open loop mode. Running the engine at fast idle will warm up oxygen sensor.

NOTE: No attempt should be made to measure oxygen sensor voltage output. Current drain of conventional voltmeter could permanently damage sensor, shift sensor calibration range and/or render sensor unusable. Do not connect jumper wire, test leads or other electrical connectors to sensor. Use these devices only on ECM side of harness after disconnecting from sensor.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.