Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Checking Alignment
Select correct wood blocks for series car being checked. Install blocks between rear axle housing and frame. Install hold down clamps as shown in illustration, adjust turnbuckles on clamps until blocks fit snugly. Block usage is as follows: Cutlass series, BT-6818; Delta and 98 series (except 1972 Delta series wagon), BT-6511-1; 1972 Delta series wagon, BT-7204.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.