Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Bleeding Hydraulic System
Fill reservoir to proper level and let oil remain undisturbed for at least two minutes. Start engine and run at idle speed for a short time, add necessary oil to maintain fluid at proper level. Raise front wheels off floor, increase engine speed to approximately 1500 RPM and turn wheels full right and left, contacting stops lightly. Lower car and turn wheels right and left. Check oil level and refill as necessary. Continue process as long as necessary to bleed all air from system.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.