Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE1969CUTLASS 7.5L ENG, ENG CD US, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALFUEL SYSTEMROCHESTER 2GC & 2GV 2-BARRELADJUSTMENTFLOAT DROP (PLASTIC FLOATS)
1969 Oldsmobile Cutlass 7.5L Eng, Eng CD US, Standard Trans
Float Drop (Plastic Floats)
1969 Oldsmobile Cutlass 7.5L Eng, Eng CD US, Standard TransSECTION Float Drop (Plastic Floats)
With air horn gasket in place, hold air horn upright and measure distance from gasket face to notch on free end of float (see Fig 1). If this distance not correct (see Specifications ), adjust by bending float arm tang as shown.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.