SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSOLDSMOBILE1969CUTLASS 7.5L ENG, ENG CD UD, NOT AVAILABLE TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)HEATING, VENTILATION & A/C (HVAC)HVAC CONTROL SYSTEMSCOMPONENT REPLACEMENTGENERAL MOTORS - OLDSMOBILEEXPANSION VALVE1969 OLDSMOBILE (ALL MODELS)REPLACEMENT
1969 Oldsmobile Cutlass 7.5L Eng, Eng CD UD, Not Available Trans

1969 Oldsmobile (All Models): Replacement

1969 Oldsmobile Cutlass 7.5L Eng, Eng CD UD, Not Available TransSECTION Replacement

Expansion valve may be removed after removing evaporator from engine compartment. On bench, remove expansion valve, peel back insulating material for access to capillary bulb retaining clamps. Remove clamps securing expansion valve. To install reverse removal procedure.

NOTE: It is important that capillary tube be tightly clamped to suction line at evaporator. Both line and tube should be clean at points of contact. Do not kink tubes when installing or removing.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.