Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Brush Assembly
Remove brush holder assembly by detaching two brush holder attaching screws. If brushes worn or oil soaked, replace. Replaced springs if weak or distorted. After brushes and springs assembled in holder, insert straight wire or pin through holes in bottom of holder to retain brushes. Mount assembly in end frame with wire protruding through hole in end frame so that it can be withdrawn after rotor installed which will allow brushes to contact slip rings.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.