Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2024Z PERFORMANCE, AUTOMATIC TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)MAINTENANCEMAINTENANCE REMINDER LIGHT (RESET PROCEDURES)TIRE PRESSURE MONITOR SYSTEM REMINDERTPM REMINDERS RESET - PROCEDURE 01ID REGISTRATION WITH TRANSMITTER ACTIVATION TOOL
2024 Nissan-Datsun Z Performance, Automatic Trans
ID Registration With Transmitter Activation Tool
2024 Nissan-Datsun Z Performance, Automatic TransSECTION ID Registration With Transmitter Activation Tool
- With the ignition switch in OFF position, connect CONSULT scan tool to the Data Link Connector (DLC). Turn ignition switch to ON position.
- Select "START (NISSAN BASED VHCL)".
- Touch "BCM" on "SELECT SYSTEM" screen.
- Select "AIR PRESSURE MONITOR" on "SELECT WORK ITEM" screen.
- Select "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST". Select "START".
- With the transmitter activation tool (J-45295) pushed against the front left transmitter position of the tire air valve, press the button for 5 seconds. See Fig 1.
- Register the IDs in the specified order. See ID Registration Order Specifications table. When ID registration of each wheel has been completed, a buzzer sounds as indicated, the hazard warning lights or turn signal indicators flash twice, and the indictor light on the Activation Tool goes from red to green.NOTE: For 2008 and later Titan and 2009 and later Maxima, the buzzer is eliminated.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.