Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Confirmation Procedure
Check the battery voltage is 9 V or more before work.
- PREPARATION BEFORE WORK
If "DTC CONFIRMATION PROCEDURE" is previously conducted, always turn ignition switch OFF and wait at least 60 seconds before performing the next test.
NOTE:After turning ignition switch from ON to OFF, wait at least 60 seconds or more without any switch operation of brake or door or others.
>>
GO TO 2.
- PERFORM DTC CONFIRMATION PROCEDURE
- Turn ignition switch ON.
- Check the DTC.
Is "P060A" detected?
>>
Refer to DTC Diagnosis Procedure .
>>
To check malfunction symptom before repair: Refer to Intermittent Incident .
>>
Confirmation after repair: INSPECTION END
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.