Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Function Check
2024 Nissan-Datsun Frontier SL, RWDSECTION Component Function Check
- CHECK START/STOP OFF SWITCH FUNCTION
With CONSULT
- Turn ignition switch ON.
- Select "STOP START SW" in "DATA MONITOR" mode of "BCM" using CONSULT.
- Check "STOP START SW" indication as per the following condition.
Monitor item Condition Indication STOP START SW Start/Stop OFF switch ON On OFF Off
Is the inspection result normal?
>>
INSPECTION END
>>
Proceed to Diagnosis Procedure .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.