Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC Description
DTC DETECTION LOGIC
| DTC | CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
| P34C8-00 | Camshaft position control module (Camshaft position control module performance) | Diagnosis condition | Ignition switch ON |
| Signal (terminal) | - | ||
| Threshold | Internal CPU error is detected | ||
| Diagnosis delay time | - | ||
POSSIBLE CAUSE
Electric intake valve timing (IVT) control module
FAIL-SAFE
Engine Control System
| Fail safe mode | Vehicle behavior | |
|---|---|---|
| Device fix mode |
|
|
| Combustion control mode | Stratified charge combustion control at starting | No stratified charge combustion at starting (cold start). |
| Idle speed control * | Stops feedback control of idle speed and controls with specified speed. | |
| Recovery speed control at decelerating * | Stops recovery speed control by the fuel cut at decelerating and controls with specified speed. | |
| Others | ECM stops the electric valve timing control. (The camshaft returns to the position of most retard angle.) | |
*: This control may not be executed.
Idle Start/Stop System
When a DTC is detected, the start/stop indicator lamp blinks slowly and the idle start/stop system operation is prohibited. When ECM detects error while operating the idle start/stop system, ECM restarts the engine.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.