Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC Confirmation Procedure
- CHECK DTC PRIORITY
If DTC P2617 is displayed with DTC P0335, first perform the confirmation procedure (trouble diagnosis) for DTC P0335.
Is DTC P0335 detected?
>>
Perform diagnosis for P0335. Refer to DTC Description .
>>
GO TO 2.
- PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION: Before performing the following procedure, confirm that battery voltage is more than 11 V when ignition switch ON.
>>
GO TO 3.
- PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT
- Turn ignition switch ON and wait at least 5 seconds.
- Start the engine and wait at least 5 seconds.
- Check 1st trip DTC.
Is DTC P2617 detected?
>>
Proceed to Diagnosis Procedure .
>>
To check malfunction symptom before repair: Refer to Intermittent Incident .
>>
Confirmation after repair: INSPECTION END
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.