SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2024FRONTIER SL, RWDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM (DTC/CIRCUIT DIAGNOSIS) (6 OF 6)DTC/CIRCUIT DIAGNOSISDTC P2614: INTAKE CAMSHAFT POSITION SENSORDTC CONFIRMATION PROCEDURE
2024 Nissan-Datsun Frontier SL, RWD

DTC Confirmation Procedure

2024 Nissan-Datsun Frontier SL, RWDSECTION DTC Confirmation Procedure
  1. CHECK DTC PRIORITY 

    If DTC P2614 is displayed with DTC P0340 or P1140, first perform the confirmation procedure (trouble diagnosis) for DTC P0340 or P1140.

    Is DTC P0340 or P1140 detected?

    >>

    Perform diagnosis of applicable.

    >>

    GO TO 2.

  2. PRECONDITIONING 

    If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    TESTING CONDITION: Before performing the following procedure, confirm that battery voltage is more than 11 V when ignition switch ON.

    >>

    GO TO 3.

  3. PERFORM DTC CONFIRMATION PROCEDURE 

    SYMBOL With CONSULT

    1. Turn ignition switch ON and wait at least 5 seconds.
    2. Start the engine and wait at least 5 seconds.
    3. Check 1st trip DTC.

    Is DTC P2614 detected?

    >>

    Proceed to Diagnosis Procedure .

    >>

    To check malfunction symptom before repair: Refer to Intermittent Incident .

    >>

    Confirmation after repair: INSPECTION END

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.