Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2024FRONTIER SL, RWDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM (DTC/CIRCUIT DIAGNOSIS) (5 OF 6)DTC/CIRCUIT DIAGNOSISDTC P2101: ELECTRIC THROTTLE CONTROL FUNCTIONCOMPONENT INSPECTION
2024 Nissan-Datsun Frontier SL, RWD
Component Inspection
2024 Nissan-Datsun Frontier SL, RWDSECTION Component Inspection
- CHECK THROTTLE CONTROL MOTORΒ
- Turn ignition switch OFF.
- Disconnect electric throttle control actuator harness connector.
- Check the resistance between electric throttle control actuator terminals as per the following.
Electric throttle control actuator Condition Resistance Terminal 5 6 Temperature 25 Β°C (77 Β°F) 1 - 15 Ξ©
Is the inspection result normal?
>>
INSPECTION END
>>
Replace electric throttle control actuator. Refer to Removal and Installation .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.