SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2024FRONTIER SL, RWDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM (DTC/CIRCUIT DIAGNOSIS) (5 OF 6)DTC/CIRCUIT DIAGNOSISDTC P2016: INTAKE MANIFOLD RUNNER CONTROL VALVE POSITION SENSORDTC DESCRIPTION
2024 Nissan-Datsun Frontier SL, RWD

DTC Description

2024 Nissan-Datsun Frontier SL, RWDSECTION DTC Description

DTC DETECTION LOGIC 

DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition
P2016-00 IN/MANIFOLD RUNNER POS SEN B1 (Intake manifold runner position sensor/switch circuit low bank 1) Diagnosis condition Engine running
Signal (terminal) Intake manifold runner control valve position sensor
Threshold An excessively low voltage from the sensor is sent to ECM
Diagnosis delay time 5 Second

POSSIBLE CAUSE 

  • Harness or connectors (Intake manifold runner control position sensor circuit is shorted.)
  • Intake manifold runner control position sensor

FAIL-SAFE 

Engine Control System 

Detected items Engine operating condition in fail-safe mode
Device fix mode
  • Fixes electric intake valve timing control motor in the reference position.
  • Fixes exhaust valve timing control solenoid valve in the reference position.
  • The Intake manifold runner control valve motor is turned OFF (Intake manifold runner control valve opens).

Idle Start/Stop System 

Not applicable

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.