Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Inspection
2024 Nissan-Datsun Frontier SL, RWDSECTION Component Inspection
- CHECK ICC STEERING SWITCH
- Turn ignition switch OFF.
- Disconnect combination switch (spiral cable) harness connector M68.
- Check resistance between combination switch harness connector terminals under the following conditions.
Combination switch Condition Resistance (Approx.) Connector Terminals M68 35 34 CRUISE ON/OFF switch: Pressed 0 Ω CANCEL switch: Pressed 310 Ω DISTANCE switch: Pressed 740 Ω COAST/SET switch: Pressed 1, 410 Ω ACCEL/RES switch: Pressed 2, 590 Ω All ICC steering switches: Released 5, 460 Ω
Is the inspection result normal?
>>
INSPECTION END
>>
Replace ICC steering switch. Refer to Removal and Installation .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.