Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC Description
DTC DETECTION LOGIC
| DTC | CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| P1553-00 | BAT CURRENT SENSOR (BAT CURRENT SENSOR) | Diagnosis condition | Engine running at idle |
| Signal (terminal) | Battery current sensor signal and sensor power supply 1 signal. | ||
| Threshold | The signal voltage transmitted from the sensor to ECM is higher than the amount of the maximum power generation. | ||
| Diagnosis delay time | - | ||
POSSIBLE CAUSE
- Harness or connectors (Battery current sensor circuit is open or shorted.) (Sensor power supply 1 circuit is shorted.)
- Battery current sensor
- Sensor power supply 1 circuit
FAIL-SAFE
Engine Control System
Not applicable
Idle Start/Stop System
When a DTC is detected, the start/stop indicator lamp blinks slowly and the idle start/stop system operation is prohibited. When ECM detects error while operating the idle start/stop system, ECM restarts the engine.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.