SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2024FRONTIER SL, RWDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROL SYSTEM (DTC/CIRCUIT DIAGNOSIS) (4 OF 6)DTC/CIRCUIT DIAGNOSISDTC P0456: EVAP CONTROL SYSTEMDTC CONFIRMATION PROCEDURE
2024 Nissan-Datsun Frontier SL, RWD

DTC Confirmation Procedure

2024 Nissan-Datsun Frontier SL, RWDSECTION DTC Confirmation Procedure
  1. PRECONDITIONING 

    If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    Do you have CONSULT '

    >>

    GO TO 2.

    >>

    GO TO 4.

  2. PERFORM DTC CONFIRMATION PROCEDURE-I 

    SYMBOL With CONSULT

    1. Turn ignition switch ON.
    2. On CONSULT screen, select "ENGINE">>"Data Monitor">>"EVAP DIAG READY".
    3. Start engine and wait at idle until "OFF" of "EVAP DIAG READY" changes to "ON".
      NOTE: SYMBOL It will take at most 2 hours until "OFF" of "EVAP DIAG READY" changes to "ON".
    4. Turn ignition switch OFF and wait at least 90 minutes.
      NOTE: SYMBOL Never turn ignition switch ON during 90 minutes.
    5. Turn ignition switch ON.
    6. On CONSULT screen, select "ENGINE">>"Data Monitor">>"EVAP LEAK DIAG".
    7. Check that "EVAP LEAK DIAG" indication.

    Which is displayed on CONSULT '

    CMPLT>>

    GO TO 3.

    YET>>

    Perform DTC CONFIRMATION PROCEDURE again. GO TO 1.

  3. PERFORM COMPONENT FUNCTION CHECK-II 

    Check 1st trip DTC.

    Is DTC P0456 detected?

    >>

    Proceed to Diagnosis Procedure .

    >>

    To check malfunction symptom before repair: Refer to Intermittent Incident .

    >>

    Confirmation after repair: INSPECTION END

  4. PERFORM DTC CONFIRMATION PROCEDURE 

    SYMBOL With GST

    1. Start engine and wait engine idle for at least 2 hours.
    2. Turn ignition switch OFF and wait at least 90 minutes.
      NOTE: SYMBOL Never turn ignition switch ON during 90 minutes.
    3. Turn ignition switch ON.
    4. Check 1st trip DTC.

    Is DTC P0456 detected?

    >>

    Proceed to Diagnosis Procedure .

    >>

    To check malfunction symptom before repair: Refer to Intermittent Incident .

    >>

    Confirmation after repair: INSPECTION END

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.