Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC Description
2024 Nissan-Datsun Frontier SL, RWDSECTION DTC Description
DTC DETECTION LOGIC
| DTC No. | CONSULT screen item (Trouble diagnosis content) | DTC detected condition | |
|---|---|---|---|
| C1160 | DECEL G SEN SET (Decel G sensor set) | Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | - | ||
| Threshold | When calibration of yaw rate/side/decel G sensor is not complete. | ||
| Diagnosis delay time | 1 second or less | ||
POSSIBLE CAUSE
NOTE:
Confirm if DTC is PAST or CRNT. If DTC is CRNT, proceed with Diagnosis Procedure. If DTC is PAST, clear the DTC. Do not replace the ABS actuator and electric unit (control unit) for a PAST DTC.
| PAST DTC | CRNT DTC |
|---|---|
|
|
FAIL-SAFE
The following functions are suspended:
- VDC function
- ABS function
- TCS function
- Hill start assist function
- Hill descent control function
- BLSD function
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.