Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSNISSAN-DATSUN2024FRONTIER SL, RWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASDRIVER ASSISTANCE SYSTEMREMOVAL AND INSTALLATIONFRONT CAMERA UNITREMOVAL AND INSTALLATION

2024 Nissan-Datsun Frontier SL, RWD

Removal and Installation

2024 Nissan-Datsun Frontier SL, RWDSECTION Removal and Installation

REMOVAL

Using a suitable tool release pawls and remove the front windshield glass finisher (1).

: Pawl

Courtesy of NISSAN NORTH AMERICA, INC.
Using a suitable tool release pawls and remove the front camera unit (1) from the front camera unit bracket (2).

: Pawl

Courtesy of NISSAN NORTH AMERICA, INC.
Disconnect the harness connector from the front camera unit and remove front camera unit.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

Do not touch or shock the front camera unit lens area or drop the front camera unit.
Make sure that the front camera unit harness is not twisted after installation.
Align the front camera unit cover clips with the cover bracket holes and install by hand. Do not use excessive force.
Perform "ADDITIONAL SERVICE WHEN REPLACING FRONT CAMERA UNIT" when removing or replacing the front camera unit. Refer to Work Procedure .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.