Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2024FRONTIER SL, RWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASADAS CONTROL UNIT (DTC/CIRCUIT DIAGNOSIS)DTC/CIRCUIT DIAGNOSISICC/ADAS (ADAS CONTROL UNIT 2)DTC C1B85-98: DISTANCE SENSORDTC CONFIRMATION PROCEDURE
2024 Nissan-Datsun Frontier SL, RWD
DTC Confirmation Procedure
2024 Nissan-Datsun Frontier SL, RWDSECTION DTC Confirmation Procedure
- PERFORM DTC CONFIRMATION PROCEDURE
- Turn the ignition switch OFF.
- Wait for 10 minutes or more to cool the distance sensor.
- Turn the ignition switch ON.
- Perform "All DTC Reading" with CONSULT.
- Check if the "C1B85-98" is detected as the current malfunction in "Self Diagnostic Result" of "ICC/ADAS 2".
Is "C1B85-98" detected as the current malfunction?
>>
Refer to Diagnosis Procedure .
>>
To check malfunction symptom before repair: Refer to Intermittent Incident .
>>
Confirmation after repair: INSPECTION END
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.