Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Confirmation Procedure
- CHECK DTC PRIORITY
CONSULT If DTC "C1A42-23" is displayed with DTC "U1000-01", first diagnose the DTC "U1000-01".
Is applicable DTC detected?
>>
Perform diagnosis of applicable. Refer to DTC Description .
>>
GO TO 2.
- PERFORM DTC CONFIRMATION PROCEDURE
- Start the engine.
- Turn the MAIN switch of ICC system ON.
- Perform "All DTC Reading".
- Check if "C1A42-23" is detected as the current malfunction in the "Self Diagnostic Result" of "ICC/ADAS 2".
Is "C1A42-23" detected as the current malfunction?
>>
Refer to DTC Diagnosis Procedure .
>>
To check malfunction symptom before repair: Refer to Intermittent Incident .
>>
Confirmation after repair: Inspection End.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.