Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2024FRONTIER SL, RWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASADAS CONTROL UNIT (DTC/CIRCUIT DIAGNOSIS)DTC/CIRCUIT DIAGNOSISICC/ADAS (ADAS CONTROL UNIT 2)DTC C1A27-16: ECD PWR SUPPLY CIRCDTC DESCRIPTION
2024 Nissan-Datsun Frontier SL, RWD
DTC Description
2024 Nissan-Datsun Frontier SL, RWDSECTION DTC Description
DTC DETECTION LOGIC
| DTC | CONSULT screen terms | DTC detection condition | |||
|---|---|---|---|---|---|
| (Trouble diagnosis content) | [Malfunction type] | ||||
| C1A27 | 16 | ECD PWR SUPPLY CIR (ECD power supply circuit) | [CIRC VOLT BELOW THRESHOLD] | Diagnosis condition |
|
| Signal (terminal) | - | ||||
| Threshold | ECD system power supply voltage is excessively low | ||||
| Diagnosis delay time | 60 second or more | ||||
POSSIBLE CAUSE
- ABS actuator and electric unit (control unit) power supply circuit
- ABS actuator and electric unit (control unit)
FAIL-SAFE
The following systems are canceled:
- Vehicle-to-vehicle distance control mode
- Conventional (fixed speed) cruise control mode
- Automatic Emergency Braking (AEB)
- Intelligent Forward Collision Warning (I-FCW)
- Rear Automatic Braking (RAB)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.