Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2024FRONTIER SL, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESBRAKES CONTROL SYSTEMSAUTOMATIC EMERGENCY BRAKING (DTC/CIRCUIT DIAGNOSIS)
2024 Nissan-Datsun Frontier SL, RWD
Automatic Emergency Braking (DTC/Circuit Diagnosis)
2024 Nissan-Datsun Frontier SL, RWDSECTION Automatic Emergency Braking (DTC/Circuit Diagnosis)
- DTC Index
- DTC/Circuit Diagnosis
- DTC C1A0C-82, C1A0C-83: ADAS Message Counter Failure
- DTC C1A01-16, C1A01-17: Power Supply Circuit 1
- DTC C1A03-64: Vehicle Speed Sensor
- DTC C1A04-97: Abs/TCS/VDC System
- DTC C1A12-78: Laser Beam Off Center
- DTC C1A16-97: Radar Blocked Or Stained
- DTC C1A17-44, C1A17-45, C1A17-46, C1A17-47, C1A17-48, C1A17-49: ICC Sensor
- DTC C1A18-54: Radar Aiming INCMP
- DTC C1A21-48: Unit High Temp
- DTC C1A23-97: Unit Low Temp
- DTC C1A39-97: Steering Angle Sensor
- DTC C1A50-48: ADAS Control Unit
- DTC C10B7-64: Yaw Rate Sensor
- DTC U0121-83: VDC Can 2
- DTC U0126-82: STRG Sen Can 1
- DTC U0415-82: VDC Can 1
- DTC U0428-83: STRG Sen Can 2
- DTC U1000-01: Can Comm Circuit
- DTC U1010-49: Control Unit (Can)
- Power Supply And Ground Circuit
- Automatic Emergency Braking System
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.