Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSNISSAN-DATSUN2024FRONTIER SL, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTDRIVERS ASSISTANCE SYSTEMS - ADASINTELLIGENT AROUND VIEW MONITOR SYSTEM (DTC/CIRCUIT DIAGNOSIS)DTC/CIRCUIT DIAGNOSISDTC C1A03: VHCL SPEED SE CIRCDTC DIAGNOSIS PROCEDURE

2024 Nissan-Datsun Frontier SL, RWD

DTC Diagnosis Procedure

2024 Nissan-Datsun Frontier SL, RWDSECTION DTC Diagnosis Procedure

PERFORM SELF DIAGNOSTIC RESULT
1. CONSULT
  1. Start the engine.
  2. Drive the vehicle at approx. 31 MPH (50 km/h) or more for approx. 2 minutes.
  3. Stop the vehicle.
  4. Ignition switch OFF.
    NOTE: Wait at least 10 seconds after placing ignition switch in the OFF position.
  5. Start the engine.
    NOTE: Wait at least 10 seconds after start the engine.
  6. Select "Self Diagnostic Result" mode of "ABS".
Are any DTCs detected?

YES>>

Refer to DTC Index .

NO>>

GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE
1. CONSULT
  1. Ignition switch ON.
  2. Erase DTC.
  3. Ignition switch OFF and wait at least 30 seconds.
  4. Ignition switch ON and wait at least 30 seconds or more.
  5. Select "Self Diagnostic Result" mode of "AVM".
  6. Check DTC.
Is DTC C1A03-00 detected?

YES>>

Replace around view monitor control unit. Refer to Removal and Installation .

NO>>

Inspection End.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.