Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSNISSAN-DATSUN2024FRONTIER SL, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSSECURITY CONTROL SYSTEM (DTC/CIRCUIT DIAGNOSIS)DTC/CIRCUIT DIAGNOSISDTC B2608: STARTER RELAYDTC CONFIRMATION PROCEDURE

2024 Nissan-Datsun Frontier SL, RWD

DTC Confirmation Procedure

2024 Nissan-Datsun Frontier SL, RWDSECTION DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE
1. CONSULT
  1. Ignition switch ON under the following conditions to start engine:
    - Shift selector lever: In the P (Park) position
    - Brake pedal: Depressed
  2. Wait 1 second after engine started.
  3. Select "Self Diagnostic Result" mode of "BCM".
  4. Check DTC.
Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure .

NO>>

Inspection End.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.