Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Nissan-Datsun Altima SL, AWDFACTORY OEM SERVICE PROCEDURE
Engine Control System (Pr25DD) (2 Of 3)
- Ecu Diagnosis Information
- Wiring Diagram
- Basic Inspection
- Additional Service When Replacing ECM
- Accelerator Pedal Released Position Learning
- Basic Inspection
- Diagnosis And Repair Work Flow
- EGR Volume Control Valve Closed Position Learning
- Engine Oil Data Reset
- Fuel Pressure
- How To Erase Permanent DTC
- How To Set SRT Code
- Idle Air Volume Learning
- Mixture Ratio Self-Learning Value Clear
- Service After Replacing Or Removing Engine Parts
- Throttle Valve Closed Position Learning
- VIN Registration
- Electric IVT Control Actuator Position Learning
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
