2017 Nissan-Datsun Maxima SLFACTORY OEM SERVICE PROCEDURE

Engine Room

GNSALBIA1329ZZ-329Courtesy of NISSAN NORTH AMERICA, INC.
No. Component Function
WHITE-1 IPDM E/R
  • IPDM E/R control the internal relays and the actuators. Refer to SYSTEM DESCRIPTION .
  • When CAN communication with ECM is impossible, IPDM E/R performs fail-safe control. Refer to FAILSAFE .
WHITE-2 Mass air flow sensor (with intake air temperature sensor) MASS AIR FLOW SENSOR (WITH INTAKE AIR TEMPERATURE SENSOR) 
WHITE-3 Electric throttle control actuator ELECTRIC THROTTLE CONTROL ACTUATOR 
WHITE-4 Power valve actuator 2 POWER VALVE ACTUATOR 1 AND 2 
WHITE-5 EVAP canister purge volume control solenoid valve EVAP CANISTER PURGE VOLUME CONTROL SOLENOID VALVE 
WHITE-6 VIAS control solenoid valve 2 VIAS CONTROL SOLENOID VALVE 1 AND 2 
WHITE-7 VIAS control solenoid valve 1 VIAS CONTROL SOLENOID VALVE 1 AND 2 
WHITE-8 ABS actuator and electric unit (control unit) Mainly transmits the following signal to ECM via CAN communication.
  • VDC operation signal
  • TCS operation signal

Refer to COMPONENT LOCATION (without ICC), COMPONENT LOCATION (with ICC) for detailed installation location.
WHITE-9 Power steering oil pump assembly (with power steering control module) Mainly transmits the following signal to ECM via CAN communication.
  • EPS operation signal

Refer to COMPONENT LOCATION for detailed installation location.
WHITE-10 Electronic controlled engine mount control solenoid valve ELECTRONIC CONTROLLED ENGINE MOUNT 
WHITE-11 Power valve actuator 1 POWER VALVE ACTUATOR 1 AND 2 
WHITE-12 Cooling fan motor-2 COOLING FAN MOTOR 
WHITE-13 Cooling fan motor-1 COOLING FAN MOTOR 
WHITE-14 TCM Mainly transmits the following signal to ECM via CAN communication.
  • Self diagnosis signal
  • Shift position signal
  • Output shaft revolution signal
  • Drive mode signal

Refer to COMPONENT LOCATION for detailed installation location.
WHITE-15 ECM ECM 
WHITE-16 Refrigerant pressure sensor REFRIGERANT PRESSURE SENSOR 
Refer to COMPONENT LOCATION for detailed installation location.
WHITE-17 Battery current sensor (with battery temperature sensor) BATTERY CURRENT SENSOR (WITH BATTERY TEMPERATURE SENSOR) 
WHITE-18 Cooling fan relay-2 -
WHITE-19 Cooling fan relay-3
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.