2017 Nissan-Datsun Maxima SLFACTORY OEM SERVICE PROCEDURE

Component Location

GNSALGIA0239ZZ-239Courtesy of NISSAN NORTH AMERICA, INC.
A. Engine room right side        
No. Component Function
1. IPDM E/R Transmits mainly the following signal to power steering control module via CAN communication:
2. Combination meter Transmits mainly the following signal to power steering control module via CAN communication:
The hydraulic pump electric power steering system warning lamp turns ON according to the signal received by CAN communication from the power steering control module.
3. Steering angle sensor Transmits mainly the following signal to power steering control module via CAN communication:
  • Steering angle sensor signal
4. Power steering oil pump assembly Reservoir tank POWER STEERING OIL PUMP ASSEMBLY 
Power steering oil pump
Power steering motor
Power steering control module
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.